Home ::  OBD2Repair News ::  2013 Release 1 Autocom/ Delphi Installation Instruction
首页广告

2013 Release 1 Autocom/ Delphi Installation Instruction

2013 Release 1 Autocom/ Delphi Installation Instruction

After get the 2013 release 1 autocom cdp from your supplier, what should you do next? Sure you need install the 2013.01 Autocom/ Delphi on your computer. Do as per OBD2Repair 2013 Release 1 Autocom/ Delphi Installation Instruction then you can use your autocom freely.

New Autocom like original cdp+ with 2013R1 Delphi Software

Below are the steps of 2013 Release 1 Autocom/ Delphi Installation

Step 1:    

Before install the new version 2013.R1 Autocom/Delphi
First uninstall previous versions

Delete the following folders:
WINDOWS XP:
C:ProgramsAutocom
C:ProgramsDelphi
C:Documents and SettingsAll UsersApplication DataAutocom
C:Documents and SettingsAll UsersApplication DataDelphi
C:Documents and Settings**USER**Application DataAutocom
C:Documents and Settings**USER**Application DataDelphi
C:Documents and Settings**USER**Application DataMicrosoftSystemCertificatesMy
C:Documents and SettingsDefault UserApplication DataMicrosoftSystemCertificatesMy
C:Documents and SettingsLocalServiceApplication DataMicrosoftSystemCertificatesMy
C:Documents and SettingsNetworkServiceApplication DataMicrosoftSystemCertificatesMy
WINDOWS 7 & 8:
C:Programsx86Autocom
C:Programsx86Delphi
C:users**USER**AppDataRoamingDelphi
C:users**USER**AppDataRoamingAutocom
C:users**USER**AppDataRoamingMicrosoftSystemCertificatesMy
OTHER OS:
Look similar folders.
.
Edit with Notepad:
C:WINDOWSsystem32driversetchosts
and delete:
127.0.0.1 activation.autocom.se
127.0.0.1 activation2.autocom.se
127.0.0.1 updates.autocom.se
.
Run CCleaner and clean the registry
.
Restart your computer
.
Install new version 2013.R1 Autocom Delphi

Step 2:   Turn off all internet and wi-fi on your pc before installing 2013 Release 1 Autocom / Delphi software

Step 3. Install Autocom/Delphi 2013 R1 (2.13.1)

Step 4. Install Patch to the Autocom folder(notice: need cover old file, pls consult how to install release 3 autocom delphi software)

Step 5. Start Autocom/Delphi and fill in required ID, Hardware Code & serial

Step 6. Click next and it will activate automatically success

Step 7. must to :Restart first

Step 8. Connect your VCI unit to computer then connect to CAR (OBD 2 plug)

Step 9. Start to test your VCI unit & UPDATE the firmware without INTERNET!

Step 10. Try directly to select your vehicle and make Diagnosis by autocom cdp + cigars in mouth

Post A Comment